PCR&LT

Key characteristics of all our mechanical presses are:

Top head press guides
Bottom platen stationary
Loader (and unloader) sturdy design with positive stops and large shock absorbers
Center mechanism large bearing surfaces and good seal design

Specification Data of PCR&LT Mechanical Curing Press

No.	Type		26''-Bias only	46''	48''	52.5''
1	Moving type mold open/close		Tilt-back	Tilt-back	Tilt-back	Tilt-back
2	Heating device		platen	platen	platen	platen
3	Q'TY of cavity		2 pcs	2 pcs	2 pcs	2 pcs
4	Cavity heat shield I.D		Φ660	Φ1170	Φ1220	Φ1335
5	Max.squeezing force		245 kN/Cavity	1715 kN/Cavity	1960 kN/Cavity	1715 kN/Cavity
6	Mold height		100-254	250-500	300-550	300-500
7	Max weight of top mold		170 kg/Cavity	2500 kg/Cavity	3000 kg/Cavity	3000 kg/Cavity
8	Type of center mechanism		BOM	BOM	BOM	BOM
9	Loading		Chuck	Chuck	Chuck	Chuck
10	Unloading		Wishbone	Reaphook	Wishbone	Wishbone
11	Tire data	Bead diameter	2.75-5 inch	13-20 inch	13-20 inch	15-20 inch
12		Max. tire O.D	Φ361 mm	Φ820 mm	Φ900 mm	Φ900 mm
13		Max.tire width	155 mm	300 mm	360 mm	330 mm
14		Max. green tire O.D	Φ193 mm	Φ800 mm	Φ825 mm	Φ850 mm
15		Min. green tire Height	358 mm	450 mm	500 mm	500 mm
16	Main Motor Power		5.5 kw	15 kw	18.5 kw	15/18.5 kw
17	Max. external pressure		1.4 Mpa	1.4 Mpa	1.4 Mpa	1.4 Mpa
18	Max. internal pressure		2.8 Mpa	2.8 Mpa	2.8 Mpa	2.8 Mpa
19	Power water pressure		1.8-2.1 Mpa	1.8-2.1 Mpa	1.8-2.1 Mpa	1.8-2.1 Mpa
20	Power air pressure		0.62 Mpa	0.7 Mpa	0.7 Mpa	0.7 Mpa
21	Control air pressure		0.35 Mpa	0.35 Mpa	0.35 Mpa	0.25-0.35 Mpa